![]()
Automation allows frequent measurements and provides graphs and reports just minutes after each measurement cycle. Elevations of the prisms are then measured automatically using an AMTS system. ![]() Each set of elevation measurements requires a visit by the surveyor, who then prepares and delivers a report.Īutomated: The top of each riser is fitted with a prism. Traditional: Settlement plates are traditionally monitored by a surveyor, who measures the elevation of the top of each riser. When fill approaches the top of the riser, an extension is added and step 3 is repeated.Paint, flags, cones, or fences are used to make the riser visible to equipment operators. Fill is hand-compacted around the riser to the specified level of the lift.Settlement will be calculated by comparing the subsequent measurements to the initial measurement. The initial elevation of each plate and riser is noted carefully.Settlement plates are installed at specified locations. INSTALLATION Protective cover Ground Level Grout After the installation of Metal protective boxes Inclinometer casing inclinometer casing in the are used to.Extensions to the riser, required as the height of the surcharge increases.Steel riser pipe fixed to the base plate.from any damages on account of settlements or loss of all damages for which. #BUILDING SETTLEMENT MARKER INSTALLATION GUIDE MANUAL#Monitoring settlement during construction of embankments. Manual on Uniform Traffic Control Devices for Streets and Highways U.S.Monitoring consolidation of ground treated with wick drains and surcharges.I love the feature, but they are making me a little crazy trying to get them to behave like the standard provided pins. Maybe it is a bug and not something I'm doing wrong.ĭo you know of anyone who has used this feature and maybe could confirm an issue or confirm that I'm just goofy? It doesn't seem like I should have to completely change the template pin to force a center point, but instead use the anchor points built into the tool. ![]() Normally it would be at cartesian 0X and half the pin's width Y" With the pin size being something like 51x51, I would have thought something like 0x by 25y would come up with something like that. The instructions state "The Anchor Point is the unique pixel point where the edge/point of contact of your pin is with the map. Makeing that sort of modification to the image itself would take quite a while and I have a couple hundred pins I'd have to update. #BUILDING SETTLEMENT MARKER INSTALLATION GUIDE UPDATE#You're correct, the default (which I assume is 0x by 0y) is the center of the pin.ĭo you mean to edit the image itself to try and make the very bottom tip the center? I could, but I thought it was meant to just take the template provided, update the image, and then re-upload. I've spent a fair amount of time adjusting the anchor points in the custom pins and I can get it to end up all over the place, but I've never gotten it to center to the bottom tip of the pin like the standard pins. To quickly center the embed on a specific marker, click on the button next to its coordinates on the marker list, as shown in this screenshot: You can also specify the zoom level and coordinates of the embed -do so with the syntax. The layers will appear in the very top right of your map view, where you can switch between the layers.Įdit a map, and find the BBCode beneath the View Map button, it should look something like this:Ĭopy & paste it anywhere in your article to insert the fully interactive map! Check the sidebar of this guide for ideas on alternative uses! ![]() Upload the layer image and that's it! It might be a good idea to make sure that the image is the same size if you are showing a comparison between the same image. To add a layer to a map, edit the map and click the Layers tab. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |